The purpose of valve acceptance?       Through the acceptance, the quantity and appearance of the delivered valve can be checked and checked to prevent the appearance quality damage and lack of quantity during transportation, loading and unloading, ...

Part 1: Brief introduction of PVC processing technology 1. The role of raw materials (including physical properties, chemical properties, mechanical properties of raw materials and their role in PVC); 2. The formula of PVC ; 2.1. Synergistic reaction...

A valve is a pipeline accessory. It is a device used to change the cross section of a pipeline and the direction of medium flow, and to control the pressure, flow, and temperature of the conveying medium. Specifically, it has the following purposes: ...

PVC pipes have become a popular building material due to their low cost and durability. PVC pipes can be used in most drainage, water supply, and ventilation applications. In these applications, most owners believe that PVC is a maintenance-free prod...

1. PVC (UPVC, RPVC, PVC-U) 1. The best mold temperature is 40℃. The shrinkage rate of coarse powder is 0.1~0.5%, and the shrinkage rate of fine powder is 1.5%. 2. After 24 hours at room temperature, absorb 0.02% of water. If necessary, bake at 65℃/3...

1. What is the relationship between the two?    The flow rate and flow rate of the valve mainly depend on the diameter of the valve, and it is also related to the resistance of the valve structure to the medium. At the same time, it has a certain in...

Water pipe insulation can improve the efficiency and performance of the piping system and reduce the loss of thermal effects. For areas prone to pipeline freezing, the insulation of the pipeline is the most necessary to do. If this happens, the labor...

Pipes made of high-density polyethylene (codes PE3408 and PE3608) are mainly used in industrial and municipal applications, and they are used in mains, sewers, and storm drains. The pipeline is buried deep in the ditch and must withstand the high pre...

At present, many engineering plastics have been successfully applied to mechanical parts and have achieved good results. However, the difficulty of injection molding of engineering plastics is relatively large, especially mold fouling is prone to occ...

A common question about air compressors is: "Which type of pipe fittings series should an air compressor use?" The following are the most common options:   1-PVC pipe PVC pipes are usually used, but they are not recommended for use with compressed ai...

The significance of choosing the correct valve In the fluid piping system, the valve is the control element, and its main function is to isolate the equipment and the piping system, adjust the flow, prevent backflow, adjust and drain the pressure. T...

Pipe flange is a bridge used to establish a connection between two pipes. It can be used to dismantle the piping system, temporary or mobile installation, transition between dissimilar materials and to connect in an environment that is not conducive ...